Wsw03 (Pabx* Mode Setting) - Ricoh G157 Service Manual

WSW03 (PABX* mode setting)

Selector
No.
CNG detection when sharing a
1, 5
modular wall socket with a
telephone
Detection time length of PABX*
2–4 dial tone, required for starting
dialing
Dial tone detection in PABX*
6, 7
(Private Automatic Branch
Exchange)
8 Not used.
NOTE: Selectors 2 through 4, 6 and 7 are not applicable where no PABX is
installed.
Selectors 1 and 5: CNG detection when sharing a modular wall socket with a
telephone
These selectors determine whether or not the machine detects a CNG signal when
a line is connected to a telephone sharing a modular wall socket with the machine.
Upon detection of CNG signals by the number of cycles specified by these
selectors, the machine interprets CNG as an effective signal and then starts FAX
reception.
Selectors 2 through 4: Detection time length of PABX dial tone, required for starting
dialing (Not used.)
Upon detection of the PABX dial tone for the time length set by these selectors, the
machine starts dialing. These selectors are effective only when both selectors 6
and 7 are set to "1" (Detection).
Selectors 6 and 7: Dial tone detection in PABX (Not used.)
These selectors activate or deactivate the dial tone detection function which
detects a dial tone when a line is connected to the PABX.
Setting both of these selectors to "1" activates the dial tone detection function so
that the machine starts dialing upon detection of a dial tone when a line is
connected.
Other setting combinations deactivate the dial tone detection function so that the
machine starts dialing after the specified WAIT (3.5, 5.0, or 7.0 sec.) without
detection of a dial tone when a line is connected.
SM
CÓPIA NÃO CONTROLADA
Function
5-43
CÓPIA NÃO CONTROLADA
MAINTENANCE MODE
Setting and Specifications
No. 1. 5.
0 0: 0.5 cycle
0 1: 1.0 cycle
1 0: 1.5 cycle
1 1: 2.0 cycle
(Not used.)
(Not used.)
G157