Wsw41 (On-Duration Of The Scanning Light Source); Wsw42 (Internet Mail Settings) - Ricoh G157 Service Manual

WSW41 (ON-duration of the scanning light source)

Selector
No.
ON-duration of the scanning light
1–3
source at room temperature
4 Not used.
5–8 Modem attenuator
Selectors 1 through 3: ON-duration of the scanning light source at room temperature
(Not used.)
If the scanning operation is started when the scanning light source is off, then it will
come on for scanning. These selectors determine how long the light source is ON
after scanning.
If these selectors are set to "1, 1, 1," the light source goes off immediately after the
scanning sequence.
Selectors 5 through 8: Modem attenuator
These selectors are used to adjust the transmitting level of the modem when the
reception level at the remote station is improper due to line loss. This function
applies to super G3 protocol signals.

WSW42 (Internet mail settings)

Selector
No.
Access to the incoming mail
1 (POP3) server (Periodical or on-
demand)
Access to the outgoing mail
2
(SMTP) server
3 I-FAX relay
4–8 Not used.
NOTE: WSW42 is applicable to models equipped with LAN interface.
SM
CÓPIA NÃO CONTROLADA
Function
(Not used.)
No. 5. 6. 7. 8.
Function
5-83
CÓPIA NÃO CONTROLADA
MAINTENANCE MODE
Setting and Specifications
0 0 0 0: -10 dBm
0 0 0 1: -11 dBm
0 0 1 0: -12 dBm
0 0 1 1: -13 dBm
0 1 0 0: -14 dBm
↕
1 1 1 1: -25 dBm
Setting and Specifications
0: Disable 1: Enable
0: Disable 1: Enable
0: Disable 1: Enable
G157