Firmware Switch Setting (Function Mode 10) - Ricoh G157 Service Manual

MAINTENANCE MODE

Firmware switch setting (Function mode 10)

The machine has the following firmware switch functions, which may be activated
using the operation panel. The firmware switches have been set at the factory to
comply with the communications standards of each country. Do not adjust them
unless it is necessary. For details about these switches, refer to the 5.2.4
"Firmware Switches".
Firmware Switches (WSW01 through WAW60)
WSW No.
WSW01 Dial pulse setting
WSW02 Tone signal setting
WSW03 PABX mode setting
WSW04 TRANSFER facility setting
WSW05 1st dial tone and busy tone
detection
WSW06 Redial/Pause key setting and 2nd
dial tone detection
WSW07 Dial tone setting 1
WSW08 Dial tone setting 2
WSW09 Protocol definition 1
WSW10 Protocol definition 2
WSW11 Busy tone setting
WSW12 Signal detection condition setting
WSW13 Modem setting
WSW14 AUTO ANS facility setting
WSW15 REDIAL facility setting
WSW16 Function setting 1
WSW17 Function setting 2
WSW18 Function setting 3
WSW19 Transmission speed setting
WSW20 Overseas communications mode
setting
WSW21 TAD setting 1
WSW22 ECM and call waiting caller ID
WSW23 Communications setting
WSW24 TAD setting 2
WSW25 TAD setting 3
WSW26 Function setting 4
WSW27 Function setting 5
1. Enter the "Maintenance" mode.
2. Press the "1" and "0" keys in this order.
3. The machine displays "WSW00" on the LCD and is ready to accept a firmware
switch number.
G157
CÓPIA NÃO CONTROLADA
Function
5-26
CÓPIA NÃO CONTROLADA
WSW No.
WSW28 Function setting 6
WSW29 Function setting 7
WSW30 Function setting 8
WSW31 Function setting 9
WSW32 Function setting 10
WSW33 Function setting 11
WSW34 Function setting 12
WSW35 Function setting 13
WSW36 Function setting 14
WSW37 Function setting 15
WSW38 V.34 transmission settings
WSW39 V.34 transmission speed
WSW40 V.34 modem settings
WSW41 ON-duration of the scanning light
source
WSW42 Internet mail settings
WSW43 Function setting 21
WSW44 Speeding up scanning-1
WSW45 Speeding up scanning-2
WSW46 Monitor of power ON/OFF state
and parallel port kept at high
WSW47 Switching between high- and full-
speed USB
WSW48 USB setup latency
WSW49 End-of-copying beep and print in
black
WSW50 SDAA settings
WSW51 Function setting 16
WSW52 Not used
WSW53 Function setting 17
WSW54- Not used
60
Function
SM