Printout Of Firmware Switch Data (Function Mode 11); Operation Check Of The Lcd (Function Mode 12) - Ricoh G157 Service Manual

MAINTENANCE MODE

Printout of firmware switch data (Function mode 11)

The machine prints out the settings of the firmware switches.
1. Enter the "Maintenance" mode.
2. Press the "1" key two times.
3. "PRINTING" appears on the LCD.
4. The machine prints out the configuration list.
5. After printing, the machine returns to the initial display of the maintenance
mode.

Operation Check of the LCD (Function mode 12)

This function allows you to check if the LCD on the operation panel works normally.
1. Enter the "Maintenance" mode.
2. Press the "1" and "2" keys in this order.
3. The LCD changes as shown in the
diagram.
4. Press the Black Start key. Each
time you press the Black Start key,
the LCD cycles through the displays
shown at right.
5. Press the Stop/Exit key to return to
the initial display of the maintenance
mode.
G157
CÓPIA NÃO CONTROLADA
5-28
CÓPIA NÃO CONTROLADA
Black Start key
Black Start key
Black Start key
G157S907.WMF
SM