Eeprom Customizing - Ricoh G157 Service Manual

6. Change the condition of the machine to check if the indication on the LCD
changes.
NOTE: For instance, insert paper through the document front (or rear) sensor
or the registration sensor (s), open the front cover or the document
cover, remove the toner cartridge, put some paper at the paper outlet,
insert paper from the manual feeder, load a paper tray, etc.
7. Press the "Stop/Exit key". The machine beeps for one second and returns to
the initial display of the maintenance mode
NOTE: If you have opened and closed the front cover during the above procedure,
you must open and close the front cover again after you complete the
procedure.
EEPROM Customizing (Entering of the country code for Europe/Asia.)
(Function code 52)
NOTE: This function is available only for the Asia and Europe versions and is
enabled only when a country code for Europe or Asia is entered in
Function code 74.
This function allows the user to change the country code if the country code for
Europe or Asia is entered.
1. Enter the "Maintenance" mode.
2. Press the "5" and "2" keys in this order.
3. "SET COUNTRY" and "PRESS SET KEY" appear alternately on the LCD.
4. Press the "Menu/Set key".
NOTE: 1) Asia version:
"AUSTRALIA" and "SELECT ↑↓ & SET" appear alternately.
2) Europe version:
"U.K" and "SELECT ↑↓ & SET" appear alternately.
5. Use the " " and " " keys to select the target country.
6. Press the "Menu/Set key". The machine displays "ACCEPTED" on the LCD
and goes back to standby mode.
SM
CÓPIA NÃO CONTROLADA
.
5-31
CÓPIA NÃO CONTROLADA
MAINTENANCE MODE
G157