6.5.4 OPC BELT SENSOR
The OPC belt sensor [A] is above the top
left corner of the OPC belt. The OPC belt
sensor is a reflective photosensor and finds
the markers [B][C] on the left end of the
OPC belt. The controller uses the signals
from the OPC belt sensor to calculate the
position of the horizontal joint line [D] on the
OPC belt. The copier does not use the area
around this line to make latent and toner
images.
6.5.5 QUENCHING
The erase lamp [A] is below the
contact point of the OPC belt and the
transfer belt. The erase lamp
quenches the electrical charge on
the OPC belt.
The cable on the erase lamp
connects with MCN8 on the BCU.
SM
CÓPIA NÃO CONTROLADA
[A]
[B]
[C]
[D]
[A]
6-21
CÓPIA NÃO CONTROLADA
OPC BELT
G157D923.WMFF
G157D924.WMFF
G157