Datamax E-Class Mark II Programmer's Manual page 89

802.3 – Wired Ethernet Configuration Parameters – Identifier 'WE'
The 'WE' sub-group contains network configuration parameters that apply only to the
Wired Ethernet (802.3 Specification) ethernet interface. No sub-groups are currently
defined for the 'WE' sub-group of configuration parameters, only item-value pairs.
The 'Item-Value' pairs within the 'WE' sub-group are defined by the following table:
Item
Number
1 DHCP Enable
2 Static Printer IP
Address
3 Static Printer
Subnet Mask
4 Static Printer
Default Gateway or
Router
5 PHY Mode
6 PHY Advertise Mode
7 PHY Capabilities to
Advertise
8 MTU
802.11 – Wireless Ethernet - WIFI Configuration Parameters – Identifier 'WIFI'
The 'WIFI' sub-group contains network configuration parameters that apply only to the Wireless Ethernet
(802.11 Specification) ethernet interface. Four (4) sub-groups are currently defined for the 'WIFI' sub-
group of configuration parameters and are as follows:
General WIFI Configuration Parameters – Identifier 'G'
DPAC Version 1 – Identifier 'DV1'
DPAC Version 2 (Veyron) – Identifier 'DV2'
SILEX Version 1 – Identifier 'SV1'
Class Series 2 Programmer's Manual
Extended System-Level Command Functions
Name Available
to User
(Y/N)
Y
Y
Y
Y
Y
Y
Y
Y
Value Type
Boolean Indicates if the DHCP Protocol is to
be used to automatically obtain all
required network addresses.
Formally known as IP Discovery.
String Static IP Address for the Printer in
dotted decimal notation.
String Static Subnet Mask for the Printer in
dotted decimal notation.
String Static Default Gateway (Router) IP
Address in dotted decimal notation.
Decimal Defines the ethernet PHY Mode
(Auto, 10BaseT HD, etc.)
Auto-Negotiate = 0
10BaseT Half Duplex = 1
10BaseT Full Duplex = 2
100BaseT Half Duplex = 3
100BaseT Full Duplex = 4
Decimal Defines the ethernet PHY Advertise
mode.
Auto = 0
All Capabilities = 1
Decimal Defines the ethernet PHY capabilities
to advertise.
Always = 0
Decimal Defines the Maximum Transmission
Unit size for the wired interface.
Defaults to the DEFAULT MTU from
the 'G' sub-group.
Description
77