Configuration Commands - Datamax E-Class Mark II Programmer's Manual

Printer Commands
<SOH>A
<STX>U01new data for field 01
<STX>E0005
<STX>G
<STX>xImagename<CR>
<STX>zA
Commands are available for retrieving stored label formats, updating data, and adding new
data. These techniques are used for increasing throughput; see <STX>G, Label Recall
Command "r", and Label Save Command "s".
Typical commands used in the various stages shown above are listed in the tables that
follow.

Configuration Commands

The following table lists some commands useful in controlling printer configuration.
These commands are generally effective only for the current power-up session; toggling
power restores the default configuration. See <STX>Kc for changes to the default power-
up configuration. Changing the default power-up configuration and saving objects in
printer Flash memory can reduce the data transmitted for each label and therefore
improve throughput.
Configuration
Command
<STX>A
<STX>c
<STX>e
Class Series 2 Programmer's Manual
Overview
Name
Set Date and Time
Set Continuous Paper Length
Set Edge Sensor
Description
Status command
Reprint with New Data
Records
Memory cleanup
Sets Date and Time.
Must be 0000 for gap media; not used
for reflective media.
Sets sensing for gap or registration hole
type stock.
Notes
Optional,
bidirectional
communication
required for these
commands.
Used for fast
reprints.
Typically used for
temporary storage.
Function
5