Stx Ki Gpio Input; Stx Kn Nic Reset - Datamax E-Class Mark II Programmer's Manual

STX KI GPIO Input
This command configures the GPIO input channels of the Applicator Interface Card; see
Appendix J for details.
Syntax:
Where:
STX Kn NIC Reset
This command resets the NIC to factory defaults.
Syntax:
Where:
108
Extended System-Level Command Functions
<STX>KIffnspwww<CR>
- 2 character function name abbreviation (e.g., PS [Print
ff
Start], I1 [User Input 1], etc).
- Pin number, where 1 – 8 is the valid range.
n
- Signal type, where: L = Level; P = Positive Pulse;
s
and N = Negative Pulse
- Polarity, where: 0 = Active Low; and 1 = Active High
p
- 3 character filter pulse width, in milliseconds.
www
<STX>Knx
- Specifies the action, where:
x
F = Returns the NIC to the factory default settings; or,
H = Reports settings to host (wireless, only).
Address
IP
Subnet Mask
Gateway
* Prior to introduction of the Wireless Ethernet, 192.0.0.192
was the IP default value and the Subnet Mask was 0.0.0.0.
Default Values
Wired Ethernet*
192.168.010.026
255.255.255.000
000.000.000.000
Class Series 2 Programmer's Manual
Default Values
Wireless Ethernet
192.168.010.001
255.255.255.000
000.000.000.000