Toner Supply Control; Modes Available; Detect Supply Mode - Ricoh A219 Service Manual

6.5 TONER SUPPLY CONTROL

6.5.1 Modes Available

NOTE: The following pages explain how the various settings control the
toner supply mechanism. They should not be adjusted in the field,
unless instructed to do so as a countermeasure for a specific
problem that may occur in the future.
SP30 Toner Supply
Setting Mode
Detect Supply
0 Mode
1
2
3
Fixed Supply Mode None
4
Depending on the SP30 setting, Detect Supply mode or Fixed Supply mode
is selected. If 0, 1, 2, or 3 is selected with SP30, Detect Supply mode is used.
If 4 is selected, Fixed Supply mode is used.
Note that when 2, 3, or 4 is selected, the machine will not perform the toner
near-end/or toner end detection. Normally, SP30 should always be kept at
the default setting. The following pages describe the toner supply mode
settings in detail.

6.5.2 Detect Supply Mode

In Detect Supply mode, the CPU monitors the TD sensor voltage, which
depends on the toner to carrier ratio in new developer. As the toner in the
developer is consumed, the TD sensor output voltage increases.
The TD sensor voltage is compared with the standard voltage (known as the
Target Toner Sensor Voltage), and toner is supplied when the TD sensor
output is higher than this target voltage.
The machine has two ways of calculating the target toner sensor voltage
(either the initial TD sensor setting is used, or a value can be input using
SP53); the method used depends on SP30. The toner supply amount can
also be changed using SP31 or 32.
SM
CÓPIA NÃO CONTROLADA
Target Toner
Sensor Voltage
Depends on the Depends on the
initial TD sensor TD sensor output.
setting (1.9 ± 0.1 V).
SP31
Depends on SP53 Depends on the
(input manually). TD sensor output.
SP31
Depends on the Fixed
initial TD sensor SP31
setting (1.9 ± 0.1 V).
Depends on SP53 Fixed
(input manually). SP31
Fixed
SP31
2-29
CÓPIA NÃO CONTROLADA
TONER SUPPLY
Toner Supply Toner Near/End
Amount Detection
Default setting: 0
Yes
Yes
No
No
No
A219