Service Program Mode Table - Ricoh A219 Service Manual

PROGRAM MODES

2.5 SERVICE PROGRAM MODE TABLE

1. In the Function column, comments (extra information) are in italics.
2. In the Settings column, the default value is printed in bold letters.
3. If there is a mark in the Mode No. column, copies can be made within
this SP Mode.
Mode No.
Forced Start Performs a free run with a forced start.
(Free Run) Press the
Press the
If this mode is switched on, the copier starts the free
run even if the fusing temperature has not reached
4
the required value yet.
This mode is performed with the selected paper size
and magnification ratio without the paper feed clutch
or total counter increment.
Normally, use SP7 to prevent fusing-related
service call conditions from occurring.
Free Run with A free run is performed without exposure.
Exposure Press the
Lamp Off Press the
This mode is performed with the selected paper size
5
and magnification ratio without the paper feed clutch
or total counter increment.
Normally, use SP7 to reduce the cleaning blade
load.
Misfeed Copies are made without misfeed detection by the
Detection Off registration, exit sensors, and sorter paper sensor.
Press the
reaching the set count, or when the
6 pressed.
Use this mode to check whether a paper misfeed
was caused by a sensor malfunction.
The total counter increments when copies are
made in this mode.
Free Run Performs a free run with the exposure lamp on.
Press the
Press the
This mode is performed with the selected paper size
7
and magnification ratio without the paper feed clutch
or total counter increment.
Before starting, close the platen cover to reduce
the cleaning blade load.
A219
CÓPIA NÃO CONTROLADA
Function
!
$
key to start the free tun.
key to stop the free run.
!
$
key to start the free run.
key to stop the free run.
!
key to make a copy. It stops when
!
$
key to start the free run.
key to stop the free run.
4-10
CÓPIA NÃO CONTROLADA
Settings
$
key is
SM