Sp Mode - Ricoh A219 Service Manual

2.2 SP MODE

1. Service Program Mode Access Procedure
How to enter the SP mode
1. Press the following keys in sequence.
# . -
→ →
NOTE: 1) The above procedure must be finished within 20 seconds.
2) Hold the final $ key for more than 3 seconds.
2. When SP mode is selected, "1" blinks in the Copy Counter, and a dot (•)
will appear in the top left corner of the Copy Counter. Also, the Auto
Image Density indicator starts blinking, and the magnification ratio display
turns off.
How to enter the UP mode
1. Press the following keys in sequence to enter the UP mode.
# $
→
* Hold the final $ key for more than 3 seconds.
2. How to Select the Program Number
1. By using the Number keys, enter the required program number. At this
point, the Copy Counter will be blinking, and the dot (•) will be lit.
2. When the Auto Image Density key is pressed, the number which is
currently blinking in the Copy Counter will be entered as the selected
program number.
3. Changing the Value of an SP Mode
1. Enter the desired value or setting using the Number keys.
NOTE: After changing the value (setting), the previous value (setting)
can be recalled again if the $ key is pressed at this point.
2. When the Auto Image Density key is pressed, the number which is
currently displayed in the Copy Counter will be entered as the new value
or setting, and will be stored in memory.
3. The copier is ready to accept a new program number. Repeat from step 1
or leave SP mode by turning the main switch off/on.
SM
CÓPIA NÃO CONTROLADA
4 $
→ →
4-7
CÓPIA NÃO CONTROLADA
PROGRAM MODES
A219