Program Modes; Basic Operation - Ricoh A219 Service Manual

PROGRAM MODES

2. PROGRAM MODES

2.1 BASIC OPERATION

1. Component
This copier is equipped with two program modes. One is the Service Program
(SP) Mode for factory and field technician usage, and the other is the User
Program (UP) mode for the user. Both program modes have a different
access procedure, but all the UP mode functions can be accessed from the
SP mode.
To be able to reset a service call (E5) condition using SP mode, the SP mode
can be accessed while the error condition exists. The error code will not be
displayed in the copy counter during these conditions.
2. Operation
To access these program modes, certain keys must be pressed after turning
on the main switch. After accessing, select the required mode number and
perform the procedure needed for that function. It is possible to move on to
the next required mode without exiting each time.
To exit these modes, turn the main switch off/on.
3. Display
The Copy Counter is used to display the program mode number. The
Magnification Ratio display is used to display the current value.
When the Copy Counter is blinking, and the dot is lit, the machine is ready
to accept a program mode number. (The program mode number is
displayed when you input it.) The Magnification Ratio display is blinking at
this time.
When the Copy Counter stops blinking, and the dot starts blinking, the
machine is ready to accept an adjustment value, and it may be displaying
the current adjustment value on the Magnification Ratio display.
4. Notes
1. With the exception of SP57, all copies made inside the program
modes are made with ID level 4 (center value).
A219
CÓPIA NÃO CONTROLADA
4-6
CÓPIA NÃO CONTROLADA
SM