Table of Contents
Advertisement
COPY QUALITY ADJUSTMENT
8.1 LIGHT INTENSITY ADJUSTMENT
8.1.1 Base Exposure Lamp Voltage Adjustment
When:
Every Call
Purpose:
To maintain the correct light intensity.
Adjustment
Level 2 (E0.2) of the gray scale on the OS-A3 chart should be slightly
Standard:
visible on the copy when the 4th manual image density level is selected.
How to Adjust:
SP48
How it works:
Changes the ac drive board output voltage.
1. Unplug the power cord.
2. Clean the following parts:
Item No.
Optics (mirrors, lens, filter, reflectors,
(1)
exposure glass)
Corona wires (charge and transfer) and
(2)
casings.
(3)
QL, Erase Lamp
3. Open SP33 and return the setting to the normal value if it has been
changed.
4. Place the OS-A3 test chart on the exposure glass and make a full size
copy at manual image density level 4 (center).
5. Confirm that level 2 (E0.2) of the gray scale is slightly visible on the copy.
If the image density is not correct, proceed to the following steps.
6. Enter the lamp voltage setting mode using the numeral keys (SP48).
7. Change the value with the numeral keys as follows:
If the image density is too dark: Increase the value
If the image density is too light: Decrease the value
8. Confirm that the image density is within the adjustment standard.
9. Perform the ADS adjustment. (See ADS Adjustment.)
A219
CÓPIA NÃO CONTROLADA
Section
6-50
CÓPIA NÃO CONTROLADA
Method
Damp cotton, silicone cloth, and
blower brush
Blower blush
Dry cloth and blower blush
SM
Advertisement
Table of Contents
