Rear Brake Pedal Adjustment; Rear Brake Pedal Free Play Adjustment - Husqvarna 2011 TE 630 Workshop Manual

SETTINGS AND ADJUSTMENTS
Rear brake pedal position adjustment
The position of the rear brake pedal with respect to the footrest may be adjusted
according to individual needs.
For adjusting, proceed as follows:
- Loosen the screw (1).
- turn the cam (2) in order to raise or lower the brake pedal (3) within the range
available (A);
- When finished, tighten the screw (1).
Once this adjustment is completed, adjust the free play of the pedal following the
instructions provided in paragraph "Rear brake pedal free play adjustment".

Rear brake pedal free play adjustment

The rear brake pedal (3) should have a free play (B) (5 mm) before the brakes
begin to bite. Should this not happen, operate as follows:
- loosen nut (4);
- operate the pump rod (5) to increase or decrease the free play;
- tighten nut (4) at the end of the operation.
When the free play requirement is not met, the brake pads will be subjected
to an early wear that may lead to TOTAL BRAKE INEFFECTIVENESS.
If the brake pedal feels mushy when pulled, there may be air in the brake
line or the brake may be defective. CHECK THE BRAKING SYSTEM (see
Section L).
D.18 Part. N. 8000 H2051 (02-2010)