Valve Clearance Adjustment - Husqvarna 2011 TE 630 Workshop Manual

SETTINGS AND ADJUSTMENTS

Valve clearance adjustment

Remove spark plug (1), the four head cover screws (2) and head cover.
Engage the 2nd gear and push and pull the motorcycle back and forth to bring
the piston to Top Dead Centre. In this condition, the notch on the head will be
lined up with the two dots on the camshaft drive gear as shown in the figure.
Use a feeler gauge to make sure clearance is 0.10-0.15 mm on the INTAKE side
and 0.15-0.20 mm on the EXHAUST side.
If not so, raise the retaining clip (3) using a spring tool, push rocker arm aside,
extract shim with a pair of tweezers and check shim thickness.
Depending on what you find, fit a new shim with the required thickness (repla-
cement shims are available in a 1.60 mm to 2.60 mm thickness range, in 0.05
mm increments) and set clip and rocker arm back into place.
Check valve clearances again. If clearances are correct, refit the parts you have
removed reversing the disassembly procedure.
Part. N. 8000 H2051 (02-2010) D.7