Oil Filters Removal - Husqvarna 2011 TE 630 Workshop Manual

Oil filters removal

Mesh filter
- Remove the clutch cover as described in the relevant paragraph.
- Extract mesh filter (1) from its seat using long nose pliers.
- Wash filter with petrol and blow with compressed air; refit filter with the
short pin facing outside.
Reassemble all parts, in the reverse order compared to disassembly.
Cartridge filter
- Loosen the screws (2) (8 mm wrench) and remove cover (3), spring (4) and
filter (5).
- Replace the filter (5) and make sure to fit it with the rubber end (6) facing
into the engine.
- Check the O-ring (7) and replace it if damaged.
Part. N. 8000 H2051 (02-2010)
ENGINE DISASSEMBLY
H006072
F.19
H006070
H006071
H006073