Pull out spring (7) and cartridge (8); reassemble in reverse order as for re-
moval and change the O-ring (screws 5: 9.3 Nm/ 0.95 Kgm/ 6.9 ft-lb).
Mesh filters cleaning
-
Drain engine oil as described in the relevant paragraph.
Filter on right side of engine.
-
Remove the rear brake lever (1) as follows: disengage the return spring
and use a 6 mm wrench to loosen the Allen screw (2).
-
Loosen the eleven M6-L30 screws (3) and the two M6-L40 screws (4)
using an 8 mm ring wrench and then remove the clutch cover (5) comple-
te with filter and oil pump.
-
Remove the filter (6), wash it with petrol and blow it with compressed air
and then refit it exactly in the original position.
-
Reassemble all parts in the reverse order compared to disassembly and
tighten screws to the specified torque (see Section X).
Part. N. 8000 H2051 (02-2010)
SETTINGS AND ADJUSTMENTS
D.11
8
7
8