Front Brake Lever Adjustment And Fluid Level Check - Husqvarna 2011 TE 630 Workshop Manual

Front brake lever adjustment and fluid level check

On the SMS model the lever position can be adjusted (4 settings available) to
suit the rider hand size.
To decrease the lever distance from the handgrip, turn the adjuster (B) CLOCKWI-
SE. To increase the lever distance from the handgrip, turn the adjuster (B)
COUNTER CLOCKWISE. On the TE models the adjuster (2), located on the
control lever, allows adjusting of the free play (a).
Free play (a) must be at least 3 mm.
The level of the fluid in master cylinder reservoir must never be below the minimum
value (1), which can be checked from the window on the rear side of the master
cylinder body (TE). For (SMS) model, check the level on the clear reservoir.
A decrease of the fluid level will let air into the system, hence an extension of
the lever stroke.
If the brake lever feels mushy when pulled, there may be air in the brake
line or the brake may be defective: CHECK THE BRAKING SYSTEM
(see Section "L").
Too much brake lever free play may reduce braking action: CHECK
BRAKE PAD THICKNESS (see Section "L").
Do not spill brake fluid onto any painted surface or lens (for example
lights lens).
Do not mix two brands of fluid. Completely change the brake fluid in the
brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes. In case
of contact, flush thoroughly with water and call a doctor if your eyes were
exposed.
A: to increase clearance
B: to decrease clearance
Part. N. 8000 H2051 (02-2010)
SETTINGS AND ADJUSTMENTS
D.17