Rear Brake Fluid Level Check; Air Filter Check - Husqvarna 2011 TE 630 Workshop Manual

Rear brake fluid level check

Master cylinder fluid level shall never drop below the minimum notch shown on
the clear reservoir (1).
A decrease of the fluid level will let air into the system, hence an extension of
the lever stroke.
If the brake pedal feels mushy when pulled, there may be air in the brake
lines or the brake may be defective. Since it is dangerous to operate the
motorcycle under such conditions, have the brake system immediately
checked (see Section L)
Do not spill brake fluid onto any painted surface or light lens.
Do not mix two brands of fluid. Completely change the brake fluid in the
brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes. In case
of contact, flush thoroughly with water and call a doctor if your eyes were
exposed.

Air filter check

- Insert the key in latch (1) then turn clockwise to release the saddle lock;
remove the saddle.
- Disengage rear right-hand side panel (2) from filter cover then slide it toward
vehicle front.
Part. N. 8000 H2051 (02-2010)
SETTINGS AND ADJUSTMENTS
D.19