Coolant Replacement - Husqvarna 2011 TE 630 Workshop Manual

SETTINGS AND ADJUSTMENTS

Coolant replacement

Coolant shall be replaced with cold engine and coolant.
Standard procedure
- Place a vessel on the R.H. side of the cylinder, under the coolant drain screw
(1). FIRST remove the screw (1) using a ... mm wrench, then SLOWLY open
the R.H. radiator cap (2); slope the motorcycle on the right side to drain the
coolant easily in the vessel. Reassemble the screw (1).
Fast procedure
- Place a vessel on the R.H. side of the cylinder, under the tube (3).
- Loosen clamp (4) and disconnect tube (3) from the engine.
- SLOWLY open the R.H. radiator cap (2); slope the motorcycle on the right
side to drain the coolant easily in the vessel.
- Reassemble the tube (3) and tighten the clamp (4) (See Section X or Section
F for tightening torque)
Standard procedure
- Pour the necessary quantity of coolant in the radiator then warm up the engine
in order to eliminate any possible air bubbles.
- Allow the coolant to cool down then remove cap (2) and check the level as
explained under "Coolant level check".
- Periodically check the connecting hoses (see "Section B"); this will avoid
coolant leakage and consequent engine seizure. If hoses (A) show cracks,
swelling or hardening due to sheaths desiccation, their replacement shall be
advisable.
- Check the correct tightening of the clamps (B).
D.14 Part. N. 8000 H2051 (02-2010)