Head Restraints - Skoda Rapid Owner's Manual

Adjusting the front seats
Fig. 34 Controls on the seat / controls on the sport seat

First read and observe the introductory information and safety warn-
ings on page 48.
Adjusting a seat in a forward/back direction
›
Pull lever » Fig. 34 (in the centre) in the direction of arrow
A
push the seat in the required direction.
The lock must click into place after you release the lever.
Adjusting height of seat
›
Push/pull the lever » Fig. 34 in the direction of one of the arrows
B
again.
Adjusting the angle of the seat backrest
›
Remove the load on the seat backrest (do not lean on it), pull the lever
C » Fig. 34 in the direction of arrow
the seat backrest with the back.
Fig. 35
Adjusting the seat
» Fig. 35
1
» Fig. 35
2
3 » Fig. 35 and set the desired angle of
After releasing the lever

Head restraints

Fig. 36 Head restraint: adjusting/removing

First read and observe the introductory information and safety warn-
ings on page 48.
Best protection is achieved if the top edge of the head restraint is at the same
level as the upper part of the head.
Setting height
›
Grasp the side of the head restraint with both hands and push it upwards as re-
quired.
›
To move the head restraint downwards, press and hold the safety button
» Fig. 36 with one hand and press the head restraint downwards with the
A
other hand.
Removing and installing head restraints
›
and
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the safety button
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Removing and installing rear head restraints
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
press the locking button into the opening
width of maximum 5 mm and pull out the head rest.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
, the seat backrest will remain in the set position.
C
» Fig. 36 and pull out the head restraint.
A
» Fig.
1
using a flat screwdriver with a
2
Seats and useful equipment

36, simultaneously

49