Cutting A Media; When [Near End] Error Occurs While Printing; When [Ink End] Error Occurs While Printing - Ricoh L4160 Operation Manual

Cutting a media

For a roll media, two ways are available to cut the media after printing is completed, as follows.
• When a media is cut, be careful that the printed side does not touch the floor or the printed side of
other already cut media.
• When using the take-up device, take up a cut medium using the switch of the take-up device.
1
Press the
2
Press the
3
Press
4
Press the
• The media is cut.
• When the cutting has been completed, the current mode returns to LOCAL.
• During the origin setting with the jog keys, you can also perform media cutting by pressing the
key. (

When [NEAR END] error occurs while printing

The following occurs when [NEAR END] error occurs while printing:
• When each printing has been completed, the current mode returns to LOCAL.
• When each printing has been completed, the current mode returns to LOCAL even if you are making multiple
prints consecutively (cannot perform continuous printing).
• Subsequent printing starts when you press the
each printing has been completed.
• In order to resume continuous printing, clear [NEAR END] message by performing the following procedure:
(1) Changing an ink cartridge (
(2) Press the

When [INK END] error occurs while printing

• Printing is canceled, and the current mode returns to LOCAL.
• Printing cannot be started while [INK END] warning is being displayed.
• In order to resume printing from where it has been paused, clear [NEAR END] message by performing the
following procedure:
(1) Changing an ink cartridge (
(2) Press the
2-30
key.
key.
to specify the cutting position.
key.
P.2-16)
P.1-16)
key.
P.1-16)
key.
MED I A CU T
MED I A CU T
CU T POS I T I ON
CU T POS I T I ON
0 . 0
* * CU T T I NG * *
P L E A SE WA I T
key, but the current mode returns to LOCAL after
[ EN T ]
[ ]
- - - -