Ricoh L4160 Operation Manual page 50

16
Fix the media on the take-up device.
( P.2-13)
(1) Feed the media up to the core of the roll media of the
take-up device by pressing the
• Check the media end is not caught into the slot on the
post-heater, and then feed the media.
(2) Fix the middle of the media with adhesive tape.
(3) In the same manner, fix the left side and right side of
the media.
• Make sure that the there is no slack or wrinkle on the
media in such condition that the roll media is pulled to
right and left evenly, and then stick the tape.
(4) Press the
• Depending on the media to use, attach/ remove the antistatic sheet. (
• If media floats at the detecting position, it may not be detected correctly.
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is "ON" (
remaining amount is displayed after detecting the media width.
1
Display the screen for entering media remaining
amount.
2
Press
amount.
3
Press the
2-12
key.
and key to enter the media remaining
key.
key.
P.3-12), the screen for entering media
P.1-19)
I NPU T MED I A L ENGT H
= 5 0 . 0 m
I NPU T MED I A L ENGT H
= 5 0 . 0 m