Ricoh L4160 Operation Manual page 146

Message
< L OC A L >
I N K N E A R E N D [ E N T ]
< L OC A L >
S U P P L Y I N K : MMC C Y Y K K
< L OC A L >
D AMP E R S e n s : MMC C Y Y K K
< L OC A L >
I n k O v e r f l o w : MMC C Y Y K K
< L OC A L >
D AMP E R / H I GH : MMC C Y Y K K
< L OC A L >
D AMP E R / L OW : MMC C Y Y K K
S H A K E WH I T E I N K
C A R T R I DG E S [ E N T ]
< L OC A L >
* * * ° C
M a c h i n e T EMP / H i
< L OC A L >
* * * ° C
M a c h i n e T EMP / L o
< L OC A L >
F I L T E R R E P L A C E
H E A T E R T EMP E R ROR
P OWE R O F F [ E N T ]
5-12
Cause
The ink of the ink cartridge has
been nearly used up.
Ink could not be supplied to the
damper.
The liquid level sensor abnormality
of the damper has been detected.
Overflow from the damper has been
detected.
Though a certain amount was con-
sumed, there is no change in the
damper sensor High.
Though a certain amount was con-
sumed, there is no change in the
damper sensor Low.
To prevent settling out in the white
ink pack, this is displayed periodi-
cally.
The machine temperature is high.
The machine temperature is low.
Time to replace the white ink filter with
a new one has come.
After "error 710 HEATER TEMP
ERROR" has occurred, the power is
forcibly turned off, and when you
restart it, this is displayed.
Solution
Press the key to check the rel-
evant Eco-cartridge. Be careful because
it may be INK NEAR END soon.
Perform "DAMPER ( P.5-6) " of the
maintenance. Also check the remaining
amount of ink in the Eco-cartridge.
Even if you performed this, when the
message is displayed, contact your local
distributor to call for service.
Turn off the power to the machine and
turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Perform "DAMPER ( P.5-6) " of the
maintenance. Also check the remaining
amount of ink in the cartridge.
Even if you performed this, when the
message is displayed, contact your local
distributor to call for service.
Following the procedures, shake the
white ink cartridge. ( P.1-14)
Adjust the ambient temperature of the
installation place.
Following the procedures, replace the
white ink filter. ( P.4-34)
If the ERROR 710 appears again, con-
tact your local distributor to call for ser-
vice.