Replacing The White Ink Filter - Ricoh L4160 Operation Manual

Replacing the white ink filter

Turn off the power supply of the printer and replace the white ink filter.
• When replacing the white ink filter, be sure to wear the attached goggles and the gloves. Ink
may get in your eyes.
• Organic solvent is used for ink.
If it adheres to your skin or gets in your eyes, immediately wash off with water enough.
1
Turn OFF the power of the printer.
• After turning off the power supply with the power switch at the
operation panel, move the main power switch (2 switches) at the
right surface to "o" side.
2
Open the W filter maintenance cover.
• Remove the screw of the W-filter maintenance cover, and open the cover.
3
Replace the white ink filter.
(1) Remove the fitting and the filter.
(2) Attach new filter and fix it with the fitting.
• If the fitting is not fixed enough, ink may leak. Tighten the fitting firmly.
• When removing the filter, ink in the tube may splash or drop. Before removing the filter,
cover around the filter with paper towels etc.
• When replacing the filter, be careful not to fold the tube.
4
Attach the W filter maintenance cover.
Replacing consumables
POWER OF F
Screw
W-filter maintenance cover
Fitting
Filter
Fitting
1
1
1
4
4-37