Ricoh L4160 Operation Manual page 49

13
Hold the media with the media guide gently.
• If the printing result indicates that drying is not enough, use
the media guide to improve adhesion of the media to the
Media Transfer Surface.
• Use the media guide with it hit slightly against the sheet
holder.
• Make the media pass around the center of the claw of the
media guide.
14
Prepare for the take-up device.
(1) Set an empty core of the roll media on the take-up
device.
(2) Close the front cover.
15
Press the
• Detects the media width.
• Width of the printable area that has been calculated from the detected
media width is displayed on the screen.
• Make sure that the width of the printable
• Depending on the usage conditions and loaded media, the media width may not be detected correctly.
Perform the following if the media width cannot be detected correctly:
• Remove the media and then set it again.
• Make sure that the external lighting on the media surface does not interfere with the media sensor.
• Clean the media sensor by performing the procedure described in "Cleaning the Media Sensor"
( P.4-4), Cleaning.
• When [MEDIA REMAIN] of the machine setup is "ON"
( P.3-12), the screen for entering media remaining amount is displayed after detecting the media
width.( P.2-12)
key to select "ROLL" .
area that has been detected is correct. The
printable width will be displayed shorter
than the actual media width by the left and
right margins (default: 30mm=left
15mm+right 15mm).
Setting a Media
Media press
Media guide
Front cover
Paper core
Take-up
device
MED I A S E L EC T
RO L L <
< L o c a l >
Wi d t h : 1 2 7 2 mm
1
2
> L EA F
4
5
6
2-11