Ricoh L4160 Operation Manual page 150

Message
E R ROR 5 0 5
ME D I A J AM
E R ROR 5 0 c
ME D I A W I D T H S E N S OR
E R ROR 5 0 9
HDC POS CN T
E R ROR 5 0 a
Y OR I G I N
E R ROR 5 0 f
L - S C A L E B L A C K
E R ROR 5 1 6
ME D I A S E T P O S I T I ON R
E R ROR 5 1 6
ME D I A S E T P O S I T I ON L
E R ROR 6 1 7
D AMP E R S e n s : 1 2 3 4 5 6 7 8
E R ROR 6 1 8
D AMP E R / H I GH : 1 2 3 4 5 6 7 8
E R ROR 6 1 9
D AMP E R / L OW : 1 2 3 4 5 6 7 8
E R ROR 6 1 a
I N K O v e r f l o w : 1 2 3 4 5 6 7 8
E R ROR 6 1 b
S U P P L Y I N K : 1 2 3 4 5 6 7 8
5-16
Cause
The media jam occurs.
The media width has not been
detected correctly.
A HDC position counter error
occurred.
Y-origin could not be detected.
Abnormal linear scale.
The media is set outside the proper
area.
The liquid level sensor abnormality
of the damper has been detected.
Though a certain amount was con-
sumed, there is no change in the
damper sensor High.
Though a certain amount was con-
sumed, there is no change in the
damper sensor Low.
Overflow from the damper has been
detected.
Ink could not be supplied to the
damper.
Solution
Remove the media and reset it.
Check the media set position. (
8)
Clean the media sensor. (
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Check the media set position. (
8)
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Perform "DAMPER ( P.5-6) " of the
maintenance.
Even if you performed this, when the
message is displayed, contact your
local distributor to call for service.
Perform "DAMPER ( P.5-6) " of the
maintenance. Also check the remain-
ing amount of ink in the Eco-cartridge.
Even if you performed this, when the
message is displayed, contact your
local distributor to call for service.
P.2-
P.4-4)
P.2-