Charger Damper Removal; Charger Damper™ Service - SRAM BOXXER TEAM 2015 Service Manual

C h a r g e r D a m p e r ™ S e r v i c e
C h a r g e r D a m p e r R e m o v a l
Use aluminum soft jaws to protect the Charger Damper assembly when using a vice.
Inspect each part for scratches. Do not scratch any sealing surfaces when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove the seal or o-ring. Spray isopropyl alcohol on each part and clean
with a rag. Apply SRAM® Butter to the new seal or o-ring.
1 Clamp the drive side upper tube into a bicycle stand.
Use your fingers to remove the bottom out bumper from the
2
rebound damper shaft.
3 Use a 2 mm hex wrench to remove the knob retaining screw.
Remove the low speed compression adjuster knob.
N O T I C E
2 mm
Drive side
Charger Damper™ Service 20