SRAM BOXXER TEAM 2015 Service Manual page 42

Pour RockShox® 3wt suspension fluid into the compression top
18
cap until it is approximately half full.
Use the palm of your hand or a rag to cover the compression top
19
cap, and cycle the rebound damper shaft a few times to help
pre-bleed air from the damper.
Pour additional RockShox 3wt suspension fluid into the top cap
until the fluid is level with the top.
Use your finger to remove any air bubbles from the surface of the
fluid.
C A U T I O N - E Y E H A Z A R D
Fluid may be ejected from the damper top cap assembly. Wear
safety glasses.
Fully extend the rebound damper shaft by pulling down on the
20
rebound damper shaft.
3wt
3wt
Charger Damper™ Assembly and Bleed 42