SRAM BOXXER TEAM 2015 Service Manual page 44

Make sure the rebound damper shaft is fully extended by pulling
23
down on the shaft.
Push the syringe handle down and release it. Allow the bladder to
come to its natural resting position by waiting a few moments until
the syringe stops filling.
Use a rag to cover the syringe tip and compression top cap bleed
port, then unthread and remove the syringe.
C A U T I O N - E Y E H A Z A R D
Fluid may be ejected from the damper top cap assembly if the
bladder is not in its resting position. Wear safety glasses.
24 Install the low speed compression adjuster into the compression
top cap by hand.
Install the compression top cap retaining nut by hand. Use a
25
torque wrench with a 6 mm socket to tighten to 4.8 N•m
(42 in-lb).
6 mm 4.8 N•m (42 in-lb)
Charger Damper™ Assembly and Bleed 44