SRAM BOXXER TEAM 2015 Service Manual page 38

Clamp the wrench flats on the coupler into a vise with the
4
compression top cap facing up.
Use a torque wrench with a 24 mm socket to tighten the
compression top cap to 4.5-5.5 N•m (40-50 in-lb).
Ensure the bladder does not twist during installation. If the
bladder starts to twist, unthread the compression top cap and
coupler and repeat steps 1-4.
5 Spray isopropyl alcohol on the inside and outside of the cartridge
tube. Clean the outside of the cartridge tube with a rag.
Wrap a rag around a long dowel and insert it into the cartridge
tube to clean inside the cartridge tube.
Clamp the cartridge tube into a bicycle stand with the threads at
6
the bottom and the wrench flats at the top.
N O T I C E
24 mm 4.5-5.5 N•m (40-50 in-lb)
Charger Damper™ Assembly and Bleed 38