SRAM BOXXER TEAM 2015 Service Manual page 50

Use a torque wrench with a 4 mm hex bit socket to tighten the top
5
bolt on the lower crown to 5 N•m (44 in-lb). Use a 4 mm hex bit
socket to tighten the bottom bolt on the lower crown to
5 N•m (44-lb). Tighten the top bolt to torque once more, and then
tighten the bottom to torque again.
Repeat this tightening procedure for the bolts on the other side of
the lower crown.
Use a torque wrench with a 4 mm hex bit socket to tighten the
6
two upper crown pinch bolts to 5 N•m (44 in-lb).
27.5" fork: Use a 2.5 mm hex wrench to install the brake hose in
7
the hose brace on the fork arch.
26.5" fork: Use a cable tie to connect the brake hose to the fork
arch.
Install the brake caliper according to the brake manufacturer's
instructions.
Position the front wheel in the lower leg dropouts so the hub is
8
seated in the dropouts.
Verify no parts interfere with the lower leg. Consult your brake
manufacturer's instructions if you need to adjust your disc brakes.
N O T I C E
4 mm 5 N•m (44 in-lb)
4 mm 5 N•m (44 in-lb)
Fork Installation 50