SRAM BOXXER TEAM 2015 Service Manual page 40

Remove the cartridge tube assembly from the bicycle stand, turn
11
it over, and clamp the cartridge tube assembly in the bicycle stand
so the rebound shaft is oriented downward.
Pull down on the rebound shaft.
Pour RockShox® 3wt suspension fluid into the cartridge tube until
12
it is approximately half full.
Use the palm of your hand or a rag to cover the cartridge tube,
13
and cycle the damper rebound shaft a few times to help pre-bleed
air from the damper.
Pour additional RockShox 3wt suspension fluid into the cartridge
tube until the fluid is level with the top of the tube.
Use your finger to remove any air bubbles from the surface of the
fluid.
C A U T I O N - E Y E H A Z A R D
Pull the rebound damper shaft down slowly. Failure to do so
can result in fluid ejecting from the cartridge tube. Wear safety
glasses.
3wt
3wt
Charger Damper™ Assembly and Bleed 40