Fork Installation - SRAM BOXXER TEAM 2015 Service Manual

F o r k I n s t a l l a t i o n
Slide each upper tube through the lower crown. Leave enough
10 1
clearance between the upper tube and the upper crown to install
the frame bumpers. Use a 4 mm hex wrench to tighten one of the
lower crown bolts to temporarily hold the tubes in place while you
install the bumper.
Spray isopropyl alcohol or water on the inner surfaces of each
2
frame bumper and upper tube. Reinstall the frame bumpers onto
the upper tubes.
Push and twist the upper tubes through the upper crown until
3
both upper tubes extend past the top of the upper crown by an
equal amount and at least 2 mm.
Measure the distance from the top of the upper tube to the top of
the lower crown. This distance must be 156 mm (+/- 2 mm).
4 Align the BoXXer™ logo on the drive side upper tube with the
RockShox® logo on the lower leg.
4 mm
156 mm (+/- 2 mm)

Fork Installation

49