SRAM BOXXER TEAM 2015 Service Manual page 51

Install the threaded end of the Maxle Lite DH™ through the drive
9
side of the hub until it engages the threads of the lower leg
dropout.
Use a torque wrench with a 6 mm hex bit socket to tighten the
drive side axle bolt to 5.7 N•m (50 in-lb).
10 Use a torque wrench with a 6 mm hex bit socket to tighten the
non-drive side axle bolt until you hear or feel 8 clicks or reach a
torque value of 3.4 N•m (30 in-lb).
11 Refer to your pre-service recorded settings to adjust the rebound
and compression settings on the fork.
Spray isopropyl alcohol on the entire fork and clean it with a rag.
12
This concludes the service for RockShox® BoXXer™ front suspension forks.
6 mm 5.7 N•m (50 in-lb)
6 mm 8 clicks or 3.4 N•m (30 in-lb)
Fork Installation 51