Lower Leg Removal - SRAM BOXXER TEAM 2015 Service Manual

L o w e r L e g R e m o v a l
Clamp the non-drive side upper tube into a bicycle stand.
1
Use a 5 mm hex wrench to loosen the non-drive side bottom bolt
2
3 to 4 turns.
Place an oil pan beneath the fork to catch any draining fluid. Use
3
a plastic mallet to firmly strike the non-drive side bottom bolt to
dislodge the spring shaft from the lower leg.
Use a 5 mm hex wrench to remove the bottom bolt from the lower
leg.
Firmly pull the lower leg downward until fluid begins to drain.
4
Continue pulling downward to remove the lower leg from the
non-drive side upper tube.
If the lower leg does not slide off of the upper tube, then the
press-fit of the shaft to the lower leg may still be engaged.
Reinstall the bottom bolt 2 to 3 turns and repeat steps 2-4.
Do not hit the fork arch with any tool when removing the lower leg
as this could damage the lower leg.
N O T I C E
Non-drive side
5 mm Loosen 3 to 4 turns
5 mm
Plastic mallet

Lower Leg Removal

10