SRAM BOXXER TEAM 2015 Service Manual page 25

Place a 21 mm open end wrench on the wrench flats of the
16
cartridge tube. Hold the coupler in place with the vise and turn
the wrench counter-clockwise to loosen and remove the cartridge
tube from the coupler.
Set the cartridge tube aside.
Remove the coupler, bladder, and compression top cap assembly
17
from the vise.
While holding it over an oil pan, use needle-nose pliers to remove
the compression piston assembly.
Fluid will spill from the coupler.
Pour the fluid into an oil pan.
18
19 Clamp the wrench flats of the coupler into a vice with the
compression top cap oriented upward.
Use a 6 mm socket to remove the retaining nut from the
compression top cap.
21 mm
Needle-nose pliers
6 mm
Charger Damper Removal 25