SRAM BOXXER TEAM 2015 Service Manual page 39

Install the rebound damper seal head onto the rebound damper
7
shaft with the threads oriented toward the piston.
8 Install the rebound damper, piston side first, into the top of the
cartridge tube. Use your fingers to thread the rebound damper
seal head into the top of the cartridge tube.
Place a torque wrench with a 21 mm crowfoot open end wrench on
9
the wrench flats on the rebound damper seal head. Place a
21 mm open end wrench on the wrench flats on the damper
cartridge tube.
While holding the damper cartridge tube in place, turn the
rebound damper seal head clockwise to tighten the rebound
assembly to 9-10 N•m (80-90 in-lb).
Install the crowfoot onto the torque wrench at a 90° angle to the
handle to ensure an accurate torque reading.
Insert a 2.5 mm hex wrench into the rebound shaft until it contacts
10
the rebound adjuster screw. Turn the hex wrench
counter-clockwise until it stops. The rebound adjuster is now in the
open position.
21 mm 9-10 N•m (80-90 in-lb)
2.5 mm
Charger Damper™ Assembly and Bleed
21 mm
39