SRAM BOXXER TEAM 2015 Service Manual page 9

5 Use a 4 mm hex wrench to loosen the four lower crown and two
upper crown pinch bolts clamping the upper tubes.
Do not loosen the steerer tube clamping bolt located on the
upper crown.
Slide the upper tubes down so they clear the upper crown. Leave
6
enough clearance between the upper tube and upper crown to
remove the frame bumpers.
Use a 4 mm hex wrench to tighten one of the lower crown bolts
to temporarily hold the tubes in place while you remove the frame
bumpers.
7 Use your thumb to pry the thickest section of each frame bumper
away from the upper tube. Spray isopropyl alcohol or water
between each bumper and upper tube. Twist the frame bumpers
back and forth until they are loose on the upper tubes.
Remove the frame bumpers from the upper tubes.
8 Use a 4 mm hex wrench to loosen the lower crown bolt. Slide
the tubes through the lower crown and remove the fork from the
bicycle.
Spray isopropyl alcohol on the upper tubes and crown clamping
surface and clean them with a rag.
4 mm Lower crown
4 mm
4 mm
4 mm Upper crown
Fork Removal 9