Clamp a 5/8" hex bit socket into a vise.
26
If the compression top cap came off in step 24, set the bladder on
the hex bit socket with the coupler oriented upward. Use a 25 mm
open end wrench to remove the coupler.
If the coupler came off in step 24, set the bladder on the hex bit
socket with the compression top cap oriented upward. Use a
24 mm socket wrench to remove the compression top cap.
Remove the assembly from the vise.
27
Use a pick or your fingers to remove the o-ring inside the coupler.
Use your fingers to install a new o-ring.
5/8"
5/8"
To remove the top cap
5/8"
To remove the coupler
Charger Damper Removal
24 mm
25 mm
28