Charger Damper Assembly And Bleed - SRAM BOXXER TEAM 2015 Service Manual

C h a r g e r D a m p e r ™ A s s e m b l y a n d B l e e d
Use aluminum soft jaws to protect the Charger Damper assembly when using a vice.
Inspect each part for scratches. Do not scratch any sealing surfaces when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove the seal or o-ring. Spray isopropyl alcohol on each part and clean
with a rag. Apply SRAM® Butter to the new seal or o-ring.
Use your fingers to install the bladder onto the bladder sleeve.
1
Ensure that it is centered between the ends of the sleeve.
Apply a liberal amount of SRAM Butter onto both ends of the
2
bladder.
3 Thread the compression top cap and coupler into either side of
the bladder assembly.
N O T I C E
Charger Damper™ Assembly and Bleed 37