Table of Contents
Advertisement
5.14 Fitting the front boiler cover
B Place front boiler cover on top of the folded edges of
the side panels and pull forwards until the right and
left-hand hooks click into place in the slot (
B Screw front boiler cover firmly into the side connection
plates by screwing 2 self-tapping screws through the
tabs on the boiler cover and the folded edge on the
side panels (
Fig. 16).
5.15 Fit and connect the control unit
(accessory)
You can use the following control units with the boiler:
Logamatic 4211, 4212 as well as 4321 and 4322
(accessories).
The control unit can be fitted either on top of the boiler or,
with the side-mounted control unit holder (accessory),
onto the boiler side.
Refer to the enclosed installation instructions if using the
optional control unit side holder.
Fig. 17 shows the control unit and the front cover [1] from
the back.
B Undo both screws from cover [1]. Lift off the cover.
B Fit the control unit at the front by inserting the hooks [4]
into the oval holes in the front boiler cover [5].
B Pull the control unit forwards and then tip back. The
flexible hooks [2] must latch into the rectangular
openings at the rear of the front boiler cover [3].
B Screw the base of the control unit on the left and right
of the cable entry onto the front boiler hood [6] via the
holes [7] using two self-tapping screws.
Logano plus SB615 Gas - We reserve the right to make any changes due to technical modifications.
Fig. 16).
Fig. 16 Fitting the front boiler cover
Fig. 17 Fitting the control unit
1
Cover
2
Resilient hooks
3
Rectangular openings in the front boiler cover
4
Locking tabs
5
Oval holes in front boiler cover
6
Cable entry in the front boiler cover
7
Holes for self-tapping screws
Installation of the boiler
5
23
Hide quick links:
Advertisement
Table of Contents
