B Place the rear insulation section onto the rear of the
boiler in the position dictated by the openings and
secure to the right and the left onto the wrap-around
insulation with 4 spring hooks (
5.10 Fitting the connection plates
B Insert front connection plate (with trapeze-shaped
cut-out facing downwards) over the threaded studs,
with the 2 holes at the top, and fasten with nuts
(
Fig. 10).
B Insert back connection plate (with trapeze-shaped
cut-out facing downwards) over the threaded studs,
with the 2 holes at the top, and fasten with nuts
(
Fig. 10).
The angled sections on the connection
plates should point outwards, and both the
front and rear connection plate should be
horizontally level (
B Balance the front and rear connection plates with a
spirit level.
Logano plus SB615 Gas - We reserve the right to make any changes due to technical modifications.
Fig. 9).
Fig. 10).
Installation of the boiler
Fig. 9
Positioning and securing the rear insulation
section
1
Tension springs
Fig. 10 Locating and securing the front and rear
connection plates
5
19