Boiler Positioning; Foundation And Recommended Wall Clearances - Buderus SB615 Installation And Maintenance Instructions Manual

3.5

Boiler positioning

This chapter explains how to properly position the boiler.
CAUTION: System damage due to frost!
B Install the heating system in a room
protected from the risk of frost.
3.5.1 Foundation and recommended wall
clearances
B When providing foundations or a support area, observe
the specified minimum wall clearances (values in
brackets) ( Fig. 2 and Tab. 4) so that the installation
and maintenance instructions can be followed without
difficulty. The front edge of the boiler should be flush
with the edge of the plinth.
It is useful if there is a drain outlet near the installation
location.
The support area must be flat and able to
support the applied weight, with a slight
incline to the rear to ensure ventilation of the
boiler.
Make sure there is additional space for noise
silencing.
Recommended (and minimum) wall clearances mm
Clear- Clear-
ance ance
Boiler
1)
size kW A A
1 2
145 760 1700
(460) (1200)
185 760 1700
(460) (1200)
240 800 1700
(500) (1200)
310 800 1700
(500) (1200)
400 900 1750
(1600) (1250)
510 1000 2000
(700) (1500)
640 1000 2000
(700) (1500)
Tab. 3 Wall clearances
1) For boiler installations with third party burners, dimension A2
also depends on the burner length
Logano plus SB615 Gas - We reserve the right to make any changes due to technical modifications.
Width/
Length Width Height
L B Transport
1816 900 720/1340
1816 900 720/1340
1845 970 790/1370
1845 970 790/1370
1845 970 790/1570
1980 1100 920/1730
1980 1100 920/1730
3)
.
Regulations, standards and guidelines
Fig. 2 Boiler room (for dimensions see Tab. 4),
dimensions in mm
1)
In addition to the burner length
consideration when installing a third party burner.
2)
When using a side-mounted control unit holder.
3)
Take account of burner dimensions.
3
3)
take dimension A2 into
11