Fitting The Back Plate - Buderus SB615 Installation And Maintenance Instructions Manual

5
Installation of the boiler

5.13 Fitting the back plate

For boiler sizes 145 kW to 310 kW, the rear wall is in two
parts ( Fig. 14), for boiler sizes 400 kW to 640 kW only
one part ( Fig. 15).
Boiler sizes 145 kW to 310 kW
B Secure the lower boiler cover [1] with 5 self-tapping
screws [2] to the side panels.
B Insert the upper rear panel section [4] with the Z-fold
behind the lower rear panel section, and secure onto
the side panels with four self-tapping screws [3].
B Make sure that the two upper self-tapping screws also
pass through the connection plates.
B Secure one or two cable clips [5] or a cable duct on the
fold on the upper rear panel section.
Boiler sizes 400 kW to 640 kW
B Secure the boiler cover [1]with 4 self-tapping screws
on the right and left-hand side to the side panels.
B Make sure that the two upper self-tapping screws also
pass through the connection plates.
B Secure one or two cable clips [2] or a cable duct on the
fold on the rear panel section.
22 Logano plus SB615 Gas - We reserve the right to make any changes due to technical modifications.
Fig. 14 Screwing the 2-part real panel in place (boiler
rating 145 to 310 kW).
1 Lower rear panel
2 5 self-tapping screws
3 4 self-tapping screws
4 Upper rear panel
5 Cable clamp/cable channel
Fig. 15 Screwing rear panel in place (boiler rating 400
to 600 kW)
1 Back panel
2 Cable clamp/cable channel