Table of Contents
Advertisement
Chapter 4. User Maintenance
4. Press the HOLD key.
5. Press the HOLD key.
6. Enter the start time in hours (two characters) and minutes
(two characters) for the Pattern 1 - first mode.
Note: To clear an entry or existing data, press the FL/R key.
7. Press the HOLD key.
8. Enter the desired mode for Pattern 1 - first (0 - None, 1 -
Day 1, 2 - Day 2, 3 - Night, 4 - Night (1), 5 - Night (2)).
Note: To clear an entry or existing data, press the FL/R key.
9. Press the HOLD key to store the entry.
10. To set additional mode schedules, press the volume up or
down key or press the HOLD key to move to the desired
mode.
11. Repeat steps 6-10 until all patterns and modes are set.
(There are 3 total patterns with 5 start time/modes each.)
Note: Entry Positions are listed in Table 12 on page 92.
12. Press the MEMORY key to exit the entry mode.
13. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
Table 12.
Mode Schedule Patterns - addresses & values
FF8 1 07 0 (00-29) Hold (MMDD or HHMM or 0-5) Hold
-- VALUES --
(MMDD, HHMM, or 0-5)
Start Time
Pattern 1
(HHMM)
Mode (0-5):
0=None
1=Day 1
2=Day 2
3=Night
4=Night (1)
5=Night (2)
92
Action
-- ADDRESS NOs. (00-29) --
1st MODE
2nd MODE
00
02
01
03
S-ICX (International) issued April 2002
Section 700 - Operation
Result
0-
Mode Schedule displays
000
:HHMM
PTN 1-1 Start T displays
001
:
PTN 1-1 Mode displays
Next pattern mode displays
Desired pattern mode displays
0-
Mode Schedule displays
81-
User MAINT displays
OR...
ON/OFF LED goes off
MODES
3rd MODE
4th MODE
04
06
05
07
5th MODE
08
09
S-ICX-64-700
Advertisement
Table of Contents
