Table of Contents
Advertisement
Section 700 - Operation
To erase a code stored on an FF key:
Note: You cannot use the following procedure to clear FF keys that have been assigned as trunks.
Trunk keys can only be cleared through system programming.
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key that was programmed.
4. Press the HOLD key.
To check a programmed FF key (Display Phone Only):
1. Lift the handset or press the ON/OFF key.
2. Press the CONF key.
3. Press the FF key to be checked.
4. Replace the handset or press the ON/OFF key.
Hardware Requirements
•
N/A
Considerations
•
If a new code is programmed into a key, the previously programmed code is erased.
•
FF keys assigned as trunks must be cleared using system programming before new FF
assignments can be made.
•
The System can be programmed so that MCO 1 Exchange Line Access calls automatically use
Automatic Route Selection (ARS).
•
The ANSWER key functions as listed in the table below.
Status
Idle
No incoming ring
Incoming ring
Off-Hook
Off-hook signaling
No off-hook signaling
Note: When the extension has 1 non-appearing trunk on hold and 1 non-appearing trunk at talk, ANSWER key
operation is ignored and you can't put the 2nd non-appearing trunk on hold.
S-ICX-64-700
Action
Action
Condition
Ignore.
Monitor ON (speaker) - Auto Answer for incoming ring.
Answer for off-hook signaling. Current conversation will be
put on hold automatically.
Ignore.
S-ICX (International) issued April 2002
Chapter 5. Key Telephone Features
Intercom dial tone
Programmed code displays
Cleared Function displays
Intercom dial tone
C displays
Programmed data displays
Operation when ANSWER key is pressed
Result
Result
159
Advertisement
Table of Contents
