Setting Up As A Remote Printer (Netware 3.X) - Ricoh Printer Quick Installation Manual

Using a Printer Server
S
In the [Print Server Name] box, enter the print server name.
Use the same print server name specified using NIB Setup Tool.
T
Select the [Define additional properties] check box, and then click [Create].
U
Click [Assignments], and then click [Add] in the [Assignments] area.
V
In the [Available objects] box, click the queue you created, and then click
[OK].
W
Check the settings, and then click [OK].
X
Start the print server by entering the following from the console of the
NetWare server.
If the print server is in operation, quit and restart it.
❖ To exit
CAREE: unload pserver
❖ To start
CAREE: load pserver "print_server_name"

Setting Up as a Remote Printer (NetWare 3.x)

Follow the procedure below to use the printer as a remote printer under NetWare
3.x.
Setting up using NIB Setup Tool
A
Log on to the file server as a supervisor or supervisor equivalent.
B
Start NIB Setup Tool from [Start] menu.
C
Click [Property Sheet], and then click [OK].
D
Select a printer you want to configure.
E
On the [NetWare] tab, enter the name of the print server in the [Print Server
Name] box.
F
In the [File Server Name] box, enter the name of the file server in which a
print server is created.
You can also click [Browse] to browse through available file servers.
G
In the [Print Server Operation Mode] area, click [As Remote Printer].
H
In the [Remote Printer No.] box, enter the printer number.
239