Ricoh Printer Quick Installation Manual page 68

Cleaning and Adjusting the Printer
❒ Each time the {U} or {T} key is pressed, the value increases or decreases
respectively, in increments of 1.
❒ The correction value can be set between 0 and 6.
G
Press the {# Enter} key after setting the K (black) gradation. The cursor
shifts to M (magenta).
Calibrate 1:
K:2 M:3 C/Y:3/3
H
Set the gradation correction values for M (magenta), C (cyan), and Y (yel-
low) using the same procedure as for the K (black).
I
If you finished all settings, ensure that the cursor is on the correction
value for Y (yellow), and then press the {# Enter} key.
Calibrate 1:
K:2 M:2 C/Y:2/2
The example shows the display of the control panel when the correction value
for each color is changed to 2.
J
Check [Yes] is displayed, and press the {# Enter} key to print the correc-
tion result.
K
Check gradation correction sheet 1. To save the correction values,
check [Save and exit] is displayed and press the {# Enter} key. If you do not
want to save the correction values after this procedure, press the {U} or
{T} key to display [Exit don't save], and then press the {# Enter} key.
❒ If you complete this procedure without saving the correction values, the
changes will not be applied to subsequent print jobs.
Calibrate 1:
Save and exit
Calibrate 1:
Exit don't save
This concludes the setting for correction 1. Next, proceed to correction 2.
L
Press the {T} key to display [Start Calibr. 2], and then press the {# Enter}
key.
64